CCNP将在2009年末重大改版 考试费有望部分下调
创始人
2024-04-26 11:01:04
0次

51CTO记者从思科(中国)认证部门了解到,为了顺应CCIEv4.0,CCNP将在2009年末重大改版,更改时间为2009年圣诞节左右。

原有科目:
CCNP Prerequisites
Valid CCNA certification

CCNP Exams & Recommended Training
Required Exam(s) Recommended Training
642-901 BSCI  Building Scalable Cisco Internetworks (BSCI)
642-812 BCMSN  Building Cisco Multilayer Switched Networks (BCMSN)
642-825 ISCW  Implementing Secure Converged Wide Area Networks (ISCW)
642-845 ONT  Optimizing Converged Cisco Networks (ONT)
OR
Required Exam(s) Recommended Training
642-892 Composite  Building Scalable Cisco Internetworks (BSCI)

Building Cisco Multilayer Switched Networks (BCMSN)
642-825 ISCW  Implementing Secure Converged Wide Area Networks (ISCW)
642-845 ONT  Optimizing Converged Cisco Networks (ONT)

CCNP此次改版考试科目和考试代号有重大调整;将完全跟上新版CCIE V4.0的潮流:

1、高级路由Route v1.0 考试编号:642-902 (跟之前的没多少变化,可能会把ISCW的部分内容往这里调)

2、多层交换Switch v1.0 考试编号:642-813 (基本上无多少变化 应该是把QOS放回来)

3、安全排错TShoot v1.0 考试编号:642-832 (这门顺应CCIE v4.0考试标准的2个小时排错)

 

消息称CCNP改版后考试费用将有部分下调,请大家继续关注。

1.00 Implement Layer   2 Technologies √
1.10 Implement Spanning Tree Protocol (STP)

(a) 802.1d

(b) 802.1w

(c) 801.1s

(d) Loop guard

(e) Root guard

(f) Bridge protocol data unit (BPDU) guard

(g) Storm control

(h) Unicast flooding

(i) Port roles, failure propagation, and loop guard operation
1.20 Implement VLAN and VLAN Trunking Protocol (VTP)
1.30 Implement trunk and trunk protocols, EtherChannel, and load-balance
1.40 Implement Ethernet technologies

(a) Speed and duplex

(b) Ethernet, Fast Ethernet, and Gigabit Ethernet

(c) PPP over Ethernet   (PPPoE)
1.50 Implement Switched Port Analyzer (SPAN), Remote Switched Port Analyzer (RSPAN), and flow control
1.60 Implement Frame Relay

(a) Local Management   Interface (LMI)

(b) Traffic shaping

(c) Full mesh

(d) Hub and spoke

(e) Discard eligible   (DE)
1.70 Implement High-Level   Data Link Control (HDLC) and PPP
2.00 Implement IPv4
2.10 Implement IP version   4 (IPv4) addressing, subnetting, and variable-length subnet masking (VLSM)
2.20 Implement IPv4   tunneling and Generic Routing Encapsulation (GRE)
2.30 Implement IPv4 RIP version 2 (RIPv2)
2.40 Implement IPv4 Open Shortest Path First (OSPF)

(a) Standard OSPF areas

(b) Stub area

(c) Totally stubby area

(d)   Not-so-stubby-area (NSSA)

(e) Totally NSSA

(f) Link-state advertisement (LSA) types

(g) Adjacency on a point-to-point and on a multi-access network

(h) OSPF graceful restart
2.50 Implement IPv4 Enhanced Interior Gateway Routing Protocol (EIGRP)

(a) Best path

(b) Loop-free paths

(c) EIGRP operations when alternate loop-free paths are available, and when they are not available

(d) EIGRP queries

(e) Manual summarization and autosummarization

(f) EIGRP stubs
2.60 Implement IPv4 Border Gateway Protocol (BGP)

(a) Next hop

(b) Peering

(c) Internal Border Gateway Protocol (IBGP) and External Border Gateway Protocol (EBGP)
2.70 Implement policy   routing
2.80 Implement Performance Routing (PfR) and Cisco Optimized Edge Routing (OER)
2.90 Implement filtering, route redistribution, summarization, synchronization, attributes, and other advanced features
3.00 Implement IPv6
3.10 Implement IP version 6 (IPv6) addressing and different addressing types
3.20 Implement IPv6  neighbor discovery
3.30 Implement basic IPv6 functionality protocols
3.40 Implement tunneling techniques
3.50 Implement OSPF version 3 (OSPFv3)
3.60 Implement EIGRP version 6 (EIGRPv6)
3.70 Implement filtering and route redistribution
4.00 Implement MPLS Layer 3 VPNs
4.10 Implement Multiprotocol Label Switching (MPLS)
4.20 Implement Layer 3 virtual private networks (VPNs) on provider edge (PE), provider (P), and customer edge (CE) routers
4.30 Implement virtual routing and forwarding (VRF) and Multi-VRF Customer Edge (VRF-Lite)
5.00 Implement IP Multicast
5.10 Implement Protocol   Independent Multicast (PIM) sparse mode
5.20 Implement Multicast   Source Discovery Protocol (MSDP)
5.30 Implement interdomain   multicast routing
5.40 Implement   PIM Auto-Rendezvous Point (Auto-RP), unicast rendezvous point (RP), and   bootstrap router (BSR)
5.50 Implement   multicast tools, features, and source-specific multicast
5.60 Implement IPv6 multicast, PIM, and related multicast protocols, such as Multicast   Listener Discovery (MLD)
6.00 Implement Network   Security
6.01 Implement access   lists
6.02 Implement Zone Based   Firewall
6.03 Implement Unicast   Reverse Path Forwarding (uRPF)
6.04 Implement IP Source   Guard
6.05 Implement   authentication, authorization, and accounting (AAA) (configuring the AAA   server is not required, only the client-side (IOS) is configured)
6.06 Implement Control   Plane Policing (CoPP)
6.07 Implement Cisco IOS   Firewall
6.08 Implement Cisco IOS   Intrusion Prevention System (IPS)
6.09 Implement Secure   Shell (SSH)
6.10 Implement 802.1x
6.11 Implement NAT
6.12 Implement routing   protocol authentication
6.13 Implement device   access control
6.14 Implement security   features
7.00 Implement Network   Services
7.10 Implement Hot Standby   Router Protocol (HSRP)
7.20 Implement Gateway   Load Balancing Protocol (GLBP)
7.30 Implement Virtual   Router Redundancy Protocol (VRRP)
7.40 Implement Network   Time Protocol (NTP)
7.50 Implement DHCP
7.60 Implement Web Cache   Communication Protocol (WCCP)
8.00 Implement Quality of   Service (QoS)
8.10 Implement Modular QoS CLI (MQC)

(a) Network-Based   Application Recognition (NBAR)

(b)   Class-based weighted fair queuing (CBWFQ),  modified deficit round robin (MDRR), and low latency queuing (LLQ)

(c) Classification

(d) Policing

(e) Shaping

(f) Marking

(g) Weighted random   early detection (WRED) and random early detection (RED)

(h) Compression
8.20 Implement Layer 2   QoS: weighted round robin (WRR), shaped round robin (SRR), and policies
8.30 Implement link   fragmentation and interleaving (LFI) for Frame Relay
8.40 Implement generic   traffic shaping
8.50 Implement Resource   Reservation Protocol (RSVP)
8.60 Implement Cisco   AutoQoS
9.00 Troubleshoot a   Network
9.10 Troubleshoot a   complex Layer 2 network issue
9.20 Troubleshoot a   complex Layer 3 network issue
9.30 Troubleshoot a   network in response to an application problem
9.40 Troubleshoot network   services
9.50 Troubleshoot network   security
10.00 Optimize the Network
10.01 Implement syslog and   local logging
10.02 Implement IP Service   Level Agreement SLA
10.03 Implement NetFlow
10.04 Implement SPAN,   RSPAN, and router IP traffic export (RITE)
10.05 Implement Simple   Network Management Protocol (SNMP)
10.06 Implement Cisco IOS   Embedded Event Manager (EEM)
10.07 Implement Remote   Monitoring (RMON)
10.08 Implement FTP
10.09 Implement TFTP
10.10 Implement TFTP server   on router
10.11 Implement   Switch-module Configuration Protocol (SCP)
10.12 Implement HTTP and   HTTPS
10.13 Implement Telnet

【编辑推荐】

  1. CCNP:简单解析bgp路由在igp路由表中抖动
  2. 关于CCNP折扣号项目说明
  3. CCNP再认证策略及教材变更

相关内容

热门资讯

PHP新手之PHP入门 PHP是一种易于学习和使用的服务器端脚本语言。只需要很少的编程知识你就能使用PHP建立一个真正交互的...
网络中立的未来 网络中立性是什... 《牛津词典》中对“网络中立”的解释是“电信运营商应秉持的一种原则,即不考虑来源地提供所有内容和应用的...
各种千兆交换机的数据接口类型详... 千兆交换机有很多值得学习的地方,这里我们主要介绍各种千兆交换机的数据接口类型,作为局域网的主要连接设...
粉嫩如何诠释霸道 东芝M805... “霸道粉”是个什么玩意东芝M805拿过来的时候,笔者扑哧笑了,不是笑这款笔记本,而是笑这款产品的颜色...
什么是大数据安全 什么是大数据... 在《为什么需要大数据安全分析》一文中,我们已经阐述了一个重要观点,即:安全要素信息呈现出大数据的特征...
如何利用交换机和端口设置来管理... 在网络管理中,总是有些人让管理员头疼。下面我们就将介绍一下一个网管员利用交换机以及端口设置等来进行D...
全面诠释网络负载均衡 负载均衡的出现大大缓解了服务器的压力,更是有效的利用了资源,提高了效率。那么我们现在来说一下网络负载...
如何允许远程连接到MySQL数... [[277004]]【51CTO.com快译】默认情况下,MySQL服务器仅侦听来自localhos...
30分钟搞定iOS自定义相机 最近公司的项目中用到了相机,由于不用系统的相机,UI给的相机切图,必须自定义才可以。就花时间简单研究...
Windows恶意软件20年“... 在Windows的早期年代,病毒游走于系统之间,偶尔删除文件(但被删除的文件几乎都是可恢复的),并弹...